It’s reasonably easy to make and definitely inexpensive. There you have it, my side-to-side DIY RV leveler. This leveler will give you the chance to level your RV at one and a half inches.īut if you need a little more height, you can simply drive the RV up onto the small boards, giving you a three-inch lift. Make sure the marks on the long board match the center marks on the small boards. The two small pieces on the long board should have the bevel sides facing each other.Align the second short piece to this second mark on the long board.Measure the center-to-center distance (A) from that mark on the long board, then make another mark.Find that center mark on the small wood, then make a similar mark on the long board. Place the short piece with one bevel onto the long board, aligning both straight edges.Locate and mark the center of the two short pieces (on the side edge).4WD Covers Car Covers Caravan & Camper Covers Marine Covers Motocycle Covers. One end of the long board should also be beveled to make it easy to drive the RV onto it. Axle Stands & Ramps Bottle & Scissor Jacks Funnels & Syphons.
Saw another similar piece the same size, and bevel just one end.Using the belt sander, bevel this piece at both ends. 4 X TRAILER Jack Block Stabilizer Blocks 15000lbs Levelers For RV Camper Trailer - 164.85.Is this a good idea or is this just stupid and unsafe I can understand not wanting to expose the landing gear to the salt water corrosion so shortening the legs is good. Saw a piece from one of the planks, to match the measurement of the distance between the tires (B). 1 Strolling through the RV park and I'm seeing a lot of longtime park residence (include newly arrived Winter Texans) have cinder blocks under their landing gear.Then measure the ground distance between the tires (B). You need to measure the axles from center to center (A). 19 Mentioned 75 Post (s) Tagged 0 Thread (s) Anderson Jack Buckets We have been using the buckets for about 3 years this is what they look like today.
0 kommentar(er)
